Usb wall charger for eGo charging cable
This is an ego stand.
It will hold 3 egos from rolling around every where.
they fit standard ego style batteries.
Made out of a block of aluminum.
Do you like to drip? Would you just like to add some color to your unit? Well either way Big Dog has got you covered. These tips come in multiple colors just choose what you like best.
3.7 volt ultrafire battery
Protected and rated mAh
These holders are made from aluminum
They are very sturdy
You place them on a table or your desk at work.
They keep your ego upright.
So it dose not roll around every where.
As we all know they like to do.
This is a beauty ring and it made for eGo batteries
These are a nice little add on to any vapers eGo
They make it so yo can hang you eGo around you’re neck so you can never lose it.
This is the Juice club.
Its a one year membership to get 20% off each and every flavor we offer for one year.
Need a charger for you eGO
we have it waiting for you.
The light turns red while charging.
green when done charging.
This fits a eGo 510 thread.
it works with all ego batterys.
Make sure to clean your battery with a dry paper towel or something of that nature be for connecting it to your charger.
Glass broken? No Problem, we have the glass you need to keep you vaping.
Fits Protank ll NOT mini
-Nominal voltage: 3.7V
-Lowest permitted discharge voltage – 2.5 V
-Cycle life – 500 cycles
-Max charging rate – 4.5 Amps
-Max continuous discharge (8C)
-Do not short circuit – High current will be discharged
-Diameter: 18.2 +/- 0.5mm
-Height: 34.48 +/- 0.5mm
*Usa a Li-Ion charger. Do not use a NiMh charger.
*To ensure longevity, it is not recommended to allow the battery to discharge below 2.5V.
*Do discharged below 2.5 volts or cycle life/performance will be reduced. Maximum charge voltage is 4.25 volts.
*Chemical composition is lithium manganese oxide
*4.2V max charge, 3.7V nominal charge
*Safer chemistry, so is not available with a protection circuit. But that means you must guard against overcharge and overdischarge themselves.
*Slightly lower energy density than ICR, but can sustain much higher discharge and charge rates. Use these cells when an application calls for “high-drain” cells.
2.2 Ohm single coil
1.5 Ohm Dual Coil
Fits any dual coil kanger tank. Except for T series
The UCan is a e-liquid holder and Dispenser.
No more leaky bottles in your pocket.
The UCan is made of stainless steel and holds 10mil of E Juice
Unscrew the top of the can pour e-liquid in to the ucan.
Screw top back on.
Put the tip in you tank or on your addy.
Depress the plunger on the bottom and e-liquid comes out.
Repeat until full.
Then screw the no leak cap back on.
Youre all Done
These coils work in both Aspire Nautilus and Aspire Nautilus mini
These coils work on both Aspire Nautilus and Aspire Nautilus Mini.
Two in one ohm meter.
. 5 coil for Joyetech Ego One XL tank
1.8 Coil for Iclear 16B tank
Fogger V5 clone. This is a rebuildable tank.
Diameter: 0.86 inches (22mm)
Case Material: Stainless Steel
Base Material: Stainless Steel
Tank Material: Pyrex Glass
Atomizer Type: Rebuildable
Coil Compatibility: Dual-Coil
Liquid Capacity: 5ml
Dual Adjustable Airflow Rings
Removable Drip Tip
Pyrex Glass Tank
4 Wick Slots
Top Filling Design
Push-Button Post System
1 x Fogger V5 rebuildable atomizer
3 x Resistance wires
2 x Fiberglass wicks
3 x Extra screws
1 x Screw driver
2 x Black O-Rings
150W Cyclone sub tank by Sense
- 22mm Diameter
- 5ml Tank Capacity
- 150W Max Input
- Stainless Steel and Glass Construction
- Top Fill System
- Fully Adjustable Dual Airflow Control
- Copper 510 Connector
- Widebore Stainless Steel Drip Tip with Adjustable Airflow
- Cooling System
- Anti Spitback System
- One Cyclone Sub-Ohm Tank by Sense
- One Additional 316L Coil
- One Preinstalled 0.6 ohm Coil
- 50 to 150W
- Spare Glass Tank Section
Features and Specs:
- Dimensions: 3″L x 1-1/2″W x 7/8″D
- Black Billet Aluminum Body
- Super Compact! Only slightly larger than an iStick 30w
- Temperature Control Functionality
- Powered by a Single 18650 Battery (Batteries not Included)
- Sliding Ball Bearing Battery Door
- Output Wattage: 7w – 75w
- Output Joules: 5j – 50j
- Standard Atomizer Resistance: 0.2Ω – 3.0Ω
- Joule Atomizer Resistance: 0.05Ω – 0.3Ω
- Temperature Range: 200 – 580°F
- Spring Loaded 510 Atomizer Contact Pin
- 510 Threaded
- USB Charging Port
- Output Wattage: 5W – 75W
- Lowest Atomizer Resistance: 0.05Ω
- Requires one 18650 battery *batteries sold separately*
- Temp Control: 100°C – 350°C/ 212°F – 662°F
- Spring Loaded 510 Contact
- Dual Magnetic Battery Cover
- 1 x Sigelei 75W
- 1 x Silicone Case
- 1 x Micro USB Cable
- 1 x User Manual
- 1 x Asmodus Warranty Card
Manufacturer’s listed Specifications:
- Rated Capacity: 3500mAh
- Nominal Voltage: 3.7V
- Voltage at end of Discharge: 2.75V
- Max Charging Current: 6.4A
- Standard Charge: 3.2A
- Max. continuous discharge current: 48A
- Continuous discharge current: 32A
- Pulse discharging current: 64A
- Input voltage:
- DC 12-24V
- Output voltage:
- 4.1 ±1%
- 500mA CC current :
- > 450mA
- 1000mAh CC current:
- > 950mA
- Cut-off Voltage:
- 4.2V ± 0.05V
- TC Current, 0.5-1A:
- Auto recharging Threshold Value voltage:
- 3.9V ± 0.15mA
- Activation Voltage ( battery voltage < 2V):
- 0.45 ±0.15mA
- Operation Temperature:
- Storage Temperature :
- -40 – +70°C
- Compatible batteries:
- 10440, 16340, 18350, 18500, 18650, 26650 and so on.
- CE, RoHs, UL( for the plug)
- Choose 2 port or 4 port design
- Works with 26650, 22650, 18650, 17570, 18490, 17500, 17335, 16500, 16350, 16340, 14500, 10440 Batteries
- Capable of charging all batteries simultaneously
- Independent battery charge meters
- Stops charging when complete
- Reverse polarity protection
- USB port capable of charging phone, ipod, or other external device.
- INCLUDES CAR 12V CONNECTOR
- Immediately reads current charge capacity, unlike the Nitecore I2-I4 which takes a few moments
- LUC 2 port can switch between charging 2 batteries at 0.5A or 1.0A
- LUC V4 4 port can switch between charging 4 batteries at 0.5A, 1A, or 2 batteries at 2A
Manufacturer’s listed Specifications:
- High Drain- 20A constant current,
- Model: LG 18650 HG2
- Nominal Capacity: 3000mAh
- Nominal Voltage: 3.6V
- Full charge Voltage: 4.2V
- Operating Temperature (cell surface): Charge 0 ~ 50℃ , Discharge -20 ~ 75℃
- Diameter : 18.3 + 0.2/-0.3 mm ( Max. 18.5 mm )
- Height : 65.0 ± 0.2 mm ( Max. 65.2 mm )
- Weight Max. 48.0 g
- Positive terminal: Flat top
Bluetooth compatable battery charger from Efest
- 6 Bay Battery Charger
- Independent Charging Rate and Charge Monitoring
- Supports 10440/14500/14650/16340/16650/17650/17670/17350/18490/18500/18650/26500/26650
- Three Charging Currents of 0.5A/1A/2A
- Maximum Total Charging Current of 2A
- Note: Slot 1 and Slot 6 can charge at a rate of 2A, Slots 2 to 5 can be charged 0.5A or 1.0A
- Companion App for Bluetooth 4.0 Enabled Devices
- Supported by Android 4.3 and newer, iOS7 and newer (iOS7 App Pending)
- High Definition OLED Display
- Night Time Energy Saving Mode
- Stainless Steel Springs
- High Durability
- Rated for 10,000+ Tensile Activation
- Efest LUC Blu6 6 Bay Bluetooth Battery Charger
- Power Cord
- Warranty Card
This is one nightmare you’re going to not wake up from! Looking for a fruity candy vape? Then this is the juice you’ve been dreaming for! Bad dream but great juice! Also try Day Dream!